hey team
been using the mill for a year or so and its been running great. well i had my 4th axis on the left side of the table not bolted down and it fell off into the enclosure and the left side of the mill bumped into it. now when i got to mill a hole (1in dia 1/2in deep) like before using the same everything the hole is not round. i can actually fell a line at the 12 oclock and 6 oclock position inside the piece and the outside is slightly out of round.
i tried sprutcam which was what i was using and also pathpilot conversational.
i went to each motor mount and tightened those screws and everything looks fine when its running visually. after playing with this for a week now i am scratching my head. i have another call into tormach but until then anybody have any suggestions?
question 2 - anybody know of a fellow tormach user in NH or MA?
craig