[NCme]

Hi,

I have little problem with my software don't know what's happen, but before everything was good, unfortunately when today I open, I cant find right panel (where is green start) all side gone.Is this my fault or I deleted some file? please see photo.

[steryd]

U are in program editing mode, right panel is active in work modes. Use program run button, or double arrows ring button.

[steryd]

U can also use a simulation mode (the button under programming and editing mode button)

[NCme]

Unfortunately, in any mode there is no right panel (blue marked) I try to reinstall and still same.

[steryd]

If U use simulation mode Udon't need it. U use bottom line of function keysin there. I will check at work on monday if it can be changed in MP's.

[NCme]

If U use simulation mode Udon't need it. U use bottom line of function keysin there. I will check at work on monday if it can be changed in MP's.

I reckon, it doesn't matter, because panel disappear from any mode (Manual, hand wheel, MDI, test run, single or full run)

[NCme]

Ok I fixed, reinstalled with different location and its come back, thanks for your help steryd anyway

[steryd]

U just needed to reload PLC program with default settings