Hi,
I've been using CamWorks for some time now, so relatively familiar with the software but have now run into a problem that I've been stuck on for a couple of days and I'm out of ideas.
I'm trying to cut a basic square out, however I want to use tabs to prevent it form flying out or getting jammed and breaking my endmill. For this I've tried a few things.
First I tried to simply create an exclude area as can be seen in the first image. The outline of the exclude area is perfectly offset from the edge of my cutout by the width of my endmill. However, as can be seen in my second image, all I get in terms of toolpaths are the rounded corners.
I have side offsets set to 0, so that's not a problem. If I set side offset to -0.00001, then I get the expected x4 right angle toolpaths with the rounded corners. However it obviously creates a loop so it basically double backs on itself and effectively cuts the piece twice.
I tried creating a part with an island as can be seen in the third image. However now, even though side and depth offsets are set to 0, I get no toolpaths at all and the operations tree operation remains pink. Obviously if I change to a thinner diameter endmill, the paths then generate, however again, it's cutting a x4 pockets with loops.
Any ideas what is going on? Perhaps something simple that I'm not aware of, but I'm just no seeing it.