Hi forum,
due to my setup Tool offset is redundant (et. problematic) so I need to strip it out of my post processor
for the life of me i have scoured the UPG to see where to remove it but not having much luck
any guides (BTW generic Fanuc used)
Hi forum,
due to my setup Tool offset is redundant (et. problematic) so I need to strip it out of my post processor
for the life of me i have scoured the UPG to see where to remove it but not having much luck
any guides (BTW generic Fanuc used)
In the UPG go to sections, rapid moves, 1st rapid z down. Delete the <G:43>