[karthk]

Hello everyone
I was Using Fanuc 0i TC System
I have created a simulator by Connecting PSM, Sp Amp & Twin SVM. After all connected it shows 401 VRDY Off alarm.
Thn i cleared all & i have given some basic G Functions & turned on but still it shows the same. Thn i given G Functn for VRDY alarm, Thn now it showng EMG Only.
PSM is showing 0 But axes drives not ready and PMC DGN F0#6. Can anybody helpme please:wave:

[LuisEVH]

Hi!!!
I have a similar problem with a Nakamura Tome TMC-12 Control Series 21-T, this machine was working well, until a technician came to check a vibration in the Z axis servo, apparently it loaded parameters and the machine did not return to work, I have a backup of the machine parameters, I reloaded them, no alarm comes out, but it is in EMG state, I can navigate the menus, but nothing else works (spindle, hydraulic system, turret , move the axes).
Hopefully someone can help me, best regards.