Hi Everyone,
I have a Cincinnati Hawk 250 A2100 (black drives) that I do not know the history on. I have worked out most problems with it except a spindle motor or drive problem. About 50% of the time the machine will stop and start the spindle correctly. I also have to go through the alignment procedure more than once to get it to pass. When the problem happens, I command the spindle to stop. It slows down but continues to turn very slowly not stopping completely. Then I get the Alarm... I dont know if it is a drive, spindle motor, resolver, or what. One thing I have noticed is that the electric fan on the motor is very loud, as if someone put the incorrect fan on the motor. So I wonder if the motor was rebuilt and not tuned to the drive. If any one has any suggestions it would be greatly appreciated.