Hi guys,
Newbie here who just bought a G0704 mill. I plan on learning how to hand machine first and then perhaps later convert it into a cnc machine.
First question: Should I get table clamps or a vice?
Second Question: How do I know which size table clamp or vice I need to buy. The G0704 has specifications that state T-Slot: 3 @ 2.5 inch, centers 1/2 inch wide?
Third Question: Which diameter end mills should I purchase for a beginner, I am going to be cutting aluminum. I was doing some research and it seems that a 3 flute carbide end mill would be good. Could you point me to a kit that would be good for beginners that I could experiment with, I know I am going to break a few end mills so Im guessing I should start with cheap ones.
Fourth Question: Is there anything else that I would need to purchase to get up and running? So far I have the cnc machine, need to get end mills and table clamp/vice and metal off course.