Originally Posted by
dhc2beaver
Hello all
I am new to the CNC world and thought, what a better place to learn.
I recently purchased an older Techno/Isel CNC router table and am upgrading all the electronics.
I am building a new control box with 3 Gecko G320x drivers and a PMDX-126 break out board.
The table has Techno/Isel servo motors with DRC TK731 8E21 500-B encoders.
My problem is that I cant find any specs online showing what wire is what to connect the above encoders to the new Gecko drives.
I have found some data sheets online for other DRC encoders showing the wire info and they all seem to have the same colour codes, but am a little leary to just wing it.
So I thought I would use all of your experiences.
Any help would be much appreciated.
Cheers
Wayne