Hello Everyone,
Well after chasing my tail around trying to debug another problem, I am finally
back to trying to home this machine.
X, Y and Z axis work when using the MPG or entering G Code just fine.
The Y axis is wide and thus I have a slaved A motor that works just fine in general...
However, when I hit the " Ref All Home" button, the A axis motor does not move, only
the Y axis...
I have tried checking and unchecking many many variations of boxes in the Config section
without sucess...
Any ideas, why with the motor Y slaved to Motor A why when pressing the Ref All Home button
that only the Y motor moves???
Best Regards,
Preston