New to Haas programming here. I have a problem where I'm getting a .005 " step between a contoured wall and a curved surface tool path. I've tried to use wear for giggles but there's no G41 or G42 in the code so that obviously doesn't work. I tried changing the tool diameter down to see if that would blend it but nothing is working. How do I go about remedying this situation? All the moves are G1, there are no I or J call outs. Here's the first few lines. do I need to break it apart and give it the G41 and G42 codes for each side since its different sides of a pocket? Just hoping for an easier way.
G20
G0 G17 G40 G49 G80 G90
T2 M6
G0 G90 G54 X4.5 Y-5.1597 A0. S2500 M3
G43 H2 Z.25
M8
Z-2.4
G1 Z-2.5 F20.
Y-.4643
G0 Z-2.4
Z.25
X4.4902 Y.1644
Z-1.7934
G1 Z-1.8934
Y.1641 Z-1.9056
Y.1619 Z-1.9362
thanks in advance