hello everyone ,
I recently bought deckel maho 635v from 2007 , control is siemens 840D
my question is this :
I have a tool , Iscar saw mill , diameter 125mm , by the inserts it runs at 165rpm ISCAR Cutting Tools - Metal Working Tools - SGSF : 2300956 - SGSF 125-5-32K
since it needs quite a bit of momentum to slide slot a piece of titanium grade 5 , maximum is 23Nm , i'm wondering if the machine has enough.
In the machine manual it says that i can set in setup mode rpm from 20 to 800 and than i get a lot more momentum , more than enough but i know that the machine doesn't have manual gears. hopefully they don't mean setup mode limitations.. there fore 800rpm max.
So my question is if anyone has this machine does it make a difference if i put 'M41' after start spindle as that puts the machine in 1 gear.. and according to the manual i should have about 54Nm at my disposal..
thank you all!!!
Dalibor