Hi,
I can't understand why the planar finishing toolpaths keep missing a bit, the highest part of this slightly convex wing shape. I haven't had this problem before.
If I set the angle limit on the planar finish cut as zero, it's fine and it cuts the whole shape. But I want to be able to limit the angle so that I can finish the steeper sloped parts with Z finish cuts. But if I set any angle limit - 10, 30 degrees etc, it keeps skipping the same area, however it's almost level and should be included in the cut area.
I've tried lifting the clipping plane, and also adding Z height to the madcam box, but neither of these fixes it.
Any ideas? All help very much appreciated! I'm no expert but I've used Madcam for this sort of thing quite a bit and haven't had this problem before.
Thanks,
Andrew