We have a real problem with loss of torque on each stepper motors.
We cannot get enough "power" out from those motors. They starts to skip steps while driving...specially Y-axle.
The size of the motors should be big enough and there should be plenty of torque in those, but we just cannot get them work.
On X- and Z-axle there is MAE HY200-3424-0310-AL04 motors and Y-axle is driven with Sanyo Denki 103-815-7.
Stepper controller is TB6560 with Mach3 and 24V power supply.
We have tried tons of different setting on Mach3 motor tuning without result.
We also tried 36V power supply but no suggess.
Starts to be helpless situation to get the machine running perfect, but can anyone give any advice to check or tweak to make those steppers work?
Thanks!