Hi everybody.
I'am new to cnczone, and wanna know if you can help me out with a problem I'm having.
The matter is that we have a Milltronics VM-16 with a Centurion 8200 control in our shop. I was trying to use the tapping cycles (G84/G63) and none of them would work. The control just skipped the line command.
Then, checking the parameters setting, I realized that the parameter P324 (parameters-programs) was set to 0. I change the setting to 1, pressed the stop bottom and reset the machine. Then I try to run the program and it kept skipping the command line. :devious:. I went back to the parameters and the P324 was again set to 0.
Does anybody knows what shoud be done?
I really appreciate any help.:drowning:
Thanks
Popy