Hi there :-)
I'm working on a Gildemeister GAC65 lathe, and I have a problem with one of my axis Servo Drive " TDM 3.2-20-300-W0".
I connect power, and truth give feed command with my multimeter to E1, E2 (Command Pins), there are· no response.
Well. after changing the +&- Poles, motors shaft runs a little and BS Alarm LED turning on, the drive goes to disable mode.
I try to fix this problem with hardware test, but it seems ok, What you think, where I have to Check?
any help will kindly appreciated.
With Regards
Results 1 to 2 of 2
-
12-30-2017, 04:44 PM #1
Member
- Join Date
- Jul 2016
- Posts
- 108
INDRAMAT TDM-3.2 _Enable Problem!
-
01-06-2018, 04:49 PM #2
Member
- Join Date
- Jul 2016
- Posts
- 108
Re: INDRAMAT TDM-3.2 _Enable Problem!
Hi there :-D
I make solve the problem, Some Capacitors Didn't works well.
Regards
Reply With QuoteSimilar Threads
-
M-parametrs Indramat 2AD
By Smouk in forum Controller & Computer SolutionsReplies: 1Last Post: 04-04-2018, 02:10 PM -
Indramat TVR 3.1-W015-03
By richmmm in forum Servo Motors / DrivesReplies: 0Last Post: 11-01-2017, 02:10 PM -
indramat parts
By mikemcg in forum Uncategorised MetalWorking MachinesReplies: 0Last Post: 07-12-2012, 08:08 PM -
Indramat
By xclr82xtc in forum Servo Motors / DrivesReplies: 1Last Post: 10-10-2010, 08:00 AM -
Indramat software
By bigfoot in forum CNC (Mill / Lathe) Control Software (NC)Replies: 1Last Post: 12-21-2009, 04:52 PM
Tags for this Thread
Posting Permissions
