My Fusion 360 grid disappears while in Model Mode. To get it back I have to go to Sketch, Line, then quit Line. This will give me a grid for a few minutes then it goes away again. I find it really annoying. Is there a way to force it to stay?
Results 1 to 3 of 3
-
12-17-2017, 06:05 AM #1
Registered
- Join Date
- Mar 2013
- Posts
- 344
F 360 Grid Disappears While in Model Mode
-
12-17-2017, 06:10 AM #2
Community Moderator
- Join Date
- Mar 2003
- Posts
- 35538
Re: F 360 Grid Disappears While in Model Mode
At the bottom of the screen, there's an icon for grid and snap. Click on it, and check the Layout Grid checkbox.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
-
12-18-2017, 02:24 AM #3
Registered
- Join Date
- Mar 2013
- Posts
- 344
Re: F 360 Grid Disappears While in Model Mode
Gerry,
Originally Posted by ger21
Thanks. It should already be checked, but I'll verify that it is. At least I was finally able to keep the sketch from jumping around. Its possible I inadvertently unchecked the grid.
Reply With QuoteSimilar Threads
-
What is - Torque Mode? Position Mode? Speed/Velocity Mode?
By sunmix in forum Servo Motors / DrivesReplies: 48Last Post: 01-20-2024, 10:34 AM -
Drilling popup screen disappears
By Cutter7 in forum MadCAMReplies: 9Last Post: 03-02-2015, 11:17 AM -
Step Mode and Continius Mode exchanged
By iron_aro in forum Mach Software (ArtSoft software)Replies: 0Last Post: 06-04-2014, 05:42 PM -
Part mode to assembly mode
By Joesph Jackman in forum CamWorksReplies: 1Last Post: 12-21-2011, 07:41 AM -
Bridgeport Interact 2 -- tachometer mode vs. voltage mode?
By ichudov in forum Bridgeport / Hardinge MillsReplies: 2Last Post: 06-28-2010, 07:24 PM
Tags for this Thread
Posting Permissions
