Hello,
I have a problem with DDUM6V5.0 = chinese control board.
I can not run PWM spindle because I have 10V on PIN when board is switch on = like 100% of speed. I just need 0V when start.
Could you anybody help, I have tried so many combination in MACH3, but no success.
Thank you.
Thread: PWM 10V on PIN
Results 1 to 2 of 2
-
12-18-2017, 10:39 PM #1
Registered
- Join Date
- Oct 2015
- Posts
- 3
PWM 10V on PIN
-
12-28-2017, 03:35 AM #2
Registered
- Join Date
- Jan 2007
- Posts
- 626
Re: PWM 10V on PIN
Hi Marek,
I'm no expert but I have been working in this area recently. I don't know how much experience you have.
With your Controller Card , you need to choose to use ONE of TWO methods to controller your Spindle speed.
Pulse Width Modulation ( PWM 0 to 100% which is a 12V peak to peak signal ) OR a 0-10 VDC signal. PWM on you card is a constant voltage but the mark/space ratio varies depending on requested speed. 0-10 V signal is just a variable voltage for the same.
Are you getting them confused?
My problem was that my Card only had a PWM output and my VFD could only use 0 -20 mA signal or a 0-10 VDC signal.
Steve
Reply With Quote
