I want to make a Grid on my spoilboard but I can't seem to control the Depth of a V-Bit.
Any "words of wisdom" here?
Maybe I'm going about it the wrong way so...set me straight!
Thanks
I want to make a Grid on my spoilboard but I can't seem to control the Depth of a V-Bit.
Any "words of wisdom" here?
Maybe I'm going about it the wrong way so...set me straight!
Thanks
Assuming your Z is not moving while cutting, is the spoil board laying flat on the table?
Jim Dawson
Sandy, Oregon, USA
You need to tell us exactly what you are trying to do.
Meaning how are you programming the toolpaths?
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
I thank you guys fr responding, both of you.
I have designed a GRID in Vectric Aspire and am outputting in Mach3. My issue is setting the depth in the toolpath, I want the GRID to be very shallow, maybe 1/16th inch. From all the YouTube videos I've seen I don't understand how to do that.
The spoilboard has been surfaced and te router has been recently tramned. It is pretty darn flat to begin with.
Can I use a 60 degree bit or do I need a "skinnier" bit?
A 60° bit will give you a width of about 0.072 wide at 0.625 depth. Not sure what you are really asking here. Do you want the width wider than that?
Jim Dawson
Sandy, Oregon, USA
In Aspire, use a Profile Path, ON the vector, with your V Bit. Just tell it the depth you want.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
PROFILE...now I understand. I was using the "VCarve" setting & like Gary said it was way too deep.
I'll try it in a few minutes! Thanks again guys!