Hi
I have syntec 6mb controller, cannot run tool change in program or MDI.
I get mlc 76 alarm R44.11.
Tool change start and hang just before tool release then i get the alarm.
Please help
Hi
I have syntec 6mb controller, cannot run tool change in program or MDI.
I get mlc 76 alarm R44.11.
Tool change start and hang just before tool release then i get the alarm.
Please help
Could be not enough air preasure. My machine has done something similar, but never figured what it was for sure, and it only happens sometimes. Other possibility is the tool holder is not machined perfectly.
Good luck!