*12:10 AM Today
Hi*
I have syntec 6mb controller, cannot run tool change in program or MDI.
I get mlc 76 alarm R44.11.
Tool change start and hang just before tool release then i get the alarm.
Please help
Sent from my SM-G920F using Tapatalk
*12:10 AM Today
Hi*
I have syntec 6mb controller, cannot run tool change in program or MDI.
I get mlc 76 alarm R44.11.
Tool change start and hang just before tool release then i get the alarm.
Please help
Sent from my SM-G920F using Tapatalk
Check your air pressure and test using a manual release
Hey Bascil,
See. the thing about alarms is that Each Syntec Controlled machine is customized and configured by the Machine maker...
Sadly, they never seem to bother to update the alarm descriptions, or provide detailed parameter lists, etc..
I can only suspect that a sensor, or expected action is not happening...
Is this a new problem?
Did the machine work fine before?
hi everybody can anyone help me with my machine error
I think you need to look up manuals or data.. or a phone contact, for the mitsubishi Driver.. and see what AL90 is as far as the Servo Driver is concerned..
THANK YOU FRANK MAIL,
i already look on the manuals but there is no clear instructions on how to fix the alarm. do you have steps in removing the alarm.
appreciate your help.
thanks