584,837 active members*
5,512 visitors online*
Register for free
Login

Thread: UC100 Issues

Results 1 to 2 of 2
  1. #1
    Join Date
    Mar 2010
    Posts
    68

    UC100 Issues

    I went from DB25 to usb via the UC100. I think I have driver issues. Everything works as it should ecept the spindle doesnt turn on and my home switches dont work. I reloaded the UC100 drivers and it acted different but still not right. I have a Windows 8 64bit pc with CandCNC electronics. I cant seem to find much support on these UC100 controls.Any suggestions? Thanks

  2. #2
    Join Date
    Mar 2003
    Posts
    35538

    Re: UC100 Issues

    If everything else works, the problem is likely your software settings. Are you using Mach3? If so, you might want to try setting up a new profile from scratch.
    CNC Drive, the manufacturers of the UC100, have very good support. You could try emailing them.
    Gerry

    UCCNC 2017 Screenset
    http://www.thecncwoodworker.com/2017.html

    Mach3 2010 Screenset
    http://www.thecncwoodworker.com/2010.html

    JointCAM - CNC Dovetails & Box Joints
    http://www.g-forcecnc.com/jointcam.html

    (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)

Similar Threads

  1. UC100 losses contact
    By jcarpenter2 in forum UCCNC Control Software
    Replies: 11
    Last Post: 02-12-2017, 02:47 AM
  2. Question about using UC100
    By gene8522 in forum UCCNC Control Software
    Replies: 4
    Last Post: 01-30-2017, 03:41 PM
  3. UC100 Issue
    By naijin in forum Australia, New Zealand Club House
    Replies: 9
    Last Post: 03-09-2016, 05:52 AM
  4. UC100
    By naijin in forum Australia, New Zealand Club House
    Replies: 5
    Last Post: 02-01-2016, 04:04 PM
  5. UC100 w. G540
    By WORM6842 in forum ArtCam Pro
    Replies: 1
    Last Post: 09-06-2013, 04:07 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •