585,722 active members*
4,184 visitors online*
Register for free
Login

Thread: G71 parameters I, K

Results 1 to 2 of 2
  1. 01-04-2018, 06:38 PM #1
    mryellow
    mryellow is offline Registered
    Join Date
    Dec 2017
    Posts
    4

    G71 parameters I, K



    Hi, how do IK parameters work? I do not understand this. How to see it on the simulator?
    Reply With Quote Reply With Quote
  2. 01-06-2018, 04:49 AM #2
    LeWhite
    LeWhite is offline Registered
    Join Date
    Dec 2011
    Posts
    295

    Re: G71 parameters I, K

    I,J,K, are functions of XYZ they refer to roughing allowance from the finished geometry to the roughing strokes. E.G. it sets back and out roughing strokes so at the end of G71 or G72 a final roughing profile can cleanup the strokes. It is similar to a G70 cleanup but with less control. Note I/X is in radius measure and K/Z should take into account offset that would screw up a trough or groove as in type II roughing
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. DGN parameters Nakamura Tome TMC15M Fanuc OTC PMC-M how to enter PMC parameters?
    By roymanvega in forum Fanuc
    Replies: 3
    Last Post: 10-22-2020, 09:20 PM
  2. Hi, Bit for bit the parameters OP..??
    By getdog in forum Mazak, Mitsubishi, Mazatrol
    Replies: 2
    Last Post: 10-11-2012, 07:20 PM
  3. Parameters on a 21T
    By wganders in forum Fanuc
    Replies: 2
    Last Post: 07-05-2010, 08:21 AM
  4. Parameters 281 and 282 on 0T
    By guhl in forum Fanuc
    Replies: 1
    Last Post: 10-25-2009, 08:03 PM
  5. Oma parameters to pc
    By monaro mike in forum Fanuc
    Replies: 3
    Last Post: 06-08-2009, 11:43 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules