Hello all, I recently upgraded to pathpilot 2 and no real issues with the mill side of things it has been working fine straight out of the box. Today however I mounted my RapidTurn, did a quick conversational parting routine, touched off my tools etc and hit cycle start. The program runs to G30 runs back over to the part in z right to where it should start the parting, the spindle is running but it halts right there it never traverses in the x direction, just halts while the spindle sits there and turns. I bounced the controller, same behavior, ran a conversational facing routine, same deal just sits there. I am at a complete loss, anyone else see this sort of behaviour?