[iaff84]

Tormach For Sale: 1100 Ser# 3354 Built 12/2014 Bought 7/2015
Located in Muncie Indiana
$19,500 takes it all
Retirement waits
Dennis Swan 765 748 5369 or [email protected]
ATC w/low air option
Auto Oiler
PDB w/ foot control
Full enclosure w/ control relocate full metal front doors w/ laminated glass inserts
Load Meter
Full LED lighting w/remote switch
Dual Smart Cool w/ Flood and Fog Buster
Also flood rail with 4 extra flex lines
Pond pump for coolant with relay control
Second manually controlled pond pump for was down.
30 gallon coolant tank with Skimpy oil skimmer
Jog control
Santa Cruz Monitor Rack
Tooling
TTS Zero Master (Haimer) w/ 2 spare tips
Tension Compression Tapping Set
2 inch Shear-Hog
12- ER20 Holders
5- ¼ inch SS Holders
9- 3/8 inch SS Holders
5- ½ inch SS Holders
ER20 Collet set plus extras
2- ½ inch Chucks
2- ¼ inch Chucks
Digital Height Gauge w/ marble block
Tool Tightening Fixture
2- Mag bases w/ indicators
Edge Pro Tram with TTS Holder
2- Vise Parallels
Clamp Set
PLUS a lot of Misc. Parts

[iaff84]

More Pictures

[gunrunnerx]

Dennis,
If your interested in seperating out the tooling, please let le know.

Dolan

[iaff84]

Dennis,
If your interested in seperating out the tooling, please let le know.

Dolan

At this time I am more interested in selling the tooling I have left as a package deal with the 1100. I will entertain a reasonable offer for the total package.
Dennis Swan

[ewoodshop]

I'm in Indianapolis, Id be interested in the Haimer, Tram tool, the tapper, any holders. if you decide to piece out some tooling. I can pick up.
Thanks, Jim

[smorell]

I'd be interested if you are willing to separate stuff. Specifically the haimer, any TTS holders (ER or Set Screw), and most importantly, if you are willing to part with the ATC stuff, I would be interested in that.

[smorell]

I think I would be interested in these things too...


Tool Tightening Fixture
2- Mag bases w/ indicators
Edge Pro Tram with TTS Holder

[iaff84]

The tooling I have left is offered ONLY with the mill. After it is sold, if any tooling is left, I will sell. I will Not separate any options off the mill (ATC,PDB etc.)
Dennis Swan

[smorell]

The tooling I have left is offered ONLY with the mill. After it is sold, if any tooling is left, I will sell. I will Not separate any options off the mill (ATC,PDB etc.)
Dennis Swan

Sounds good! Good luck with the sale, looks super clean, looks like someone will get a great product.

[iaff84]

SOLD and GONE

[mountaindew]

SOLD and GONE

Darn, I was holding out for a great deal on the Tormach coffee cup. I broke my last one not long ago

[smorell]

=) I kind of wish I bought this...

I would like to know more about the enclosure mods you had done. I really like it!