[amanandhislaser]

Hi everyone,


Until very recently, I was using EZCad with my laser cutter on my Windows 10 OS. However, after the most recent Windows Update, I am no longer able to boot up my EZCad software. It will crash and give an MFC application error.

Has anyone else experienced this? If so, does anyone have any ideas for a workaround?

I've done some research online and have tried to run the program as an admin and have tried to run it in a clean boot, but nothing is working. Looking forward to your responses.

[Dtcrafts]

hi I have had problem with similar software you need to revert back to a previous build

To go back to an earlier build of Windows 10, open Start Menu > Settings > Update & Security > Recovery. Here you will see Go back to an earlierbuild section, with a Get started button. Click on it. The process to revert your Windows 10 back will commence.
HTH
Dave

[amanandhislaser]

Thanks for the help, man!