Hi All,
I'm currently using a trial version of meshcam and wondered if anyone else had results ?

I have tested a few variations and found the file for "usbcnc - mm " seems to run through its program ok (it errors at the start after switching on the spindle motor) but you can "play" past that error.
the problem comes once you add in a second tool. the program can pause but it will not switch off the spindle motor (so you cant change the tools).

any ideas ?

I will also contact the meshcam guys to see if they have any ideas

disclaimer : I have no knowledge of milling machines or its relevant software. I can Cad (rhino) and have printing (upmini and B9Creator) machines but this is my first forays into milling.