Hi Everyone,
I am new here, but have already found a lot of great information just reading older posts. I picked up an EZTRAK DX last year and finally hooked it up to power, and I was cutting my first part today. Everything was running smoothly, and then at line 511-512 the machine cut a section outside of the path boundary. I finished out the part, and everything was fine, it was just that one sequence. I have looked through the Gcode and I am not seeing anything that sticks out as being incorrect.
The cutter paths were defined in EZCAM Express V20 running on an XP machine. The original part was imported from a .dwg file. Finally, I am using a Post Processor that EZCAM sent me after the ones that came with the install failed to load. I am hoping someone with more knowledge than me can point me in the right direction.
Also, I ran the program a second time to see if the issue was repeatable which it is - the cutter will deviate once from the path at the same section of code (~Line 512). I have posted a picture and my code and I am hoping you guys could take a look. Does this sound like a post processor issue to you? I was thinking that if it where an encoder problem, it would not have repeated at the exact same place in the code. Thanks in advance.
Here is a picture of the part. That nice little half moon isn't supposed to be there