Hi
I have a dm2800 and the spindle will turn up so far and level off. With the belt in the middle pulley it is about 1600 rpms and it should be 3750 rpms. On the top belt it runs at about 4600 rpms and it should be 10,000 rpms. In the instructions it says to turn trim pot 2 (current limit ) all the way (CW) but it just keeps turning. And to set spindle speed range you turn trim pot 3 (ref in gain ) full CCW and that just keeps turning. As far as I know these trim pots are 15 turns. Has anybody had this problem? Are they broken? Is this my problem? Anybody have any suggestions? Maintenance man at work thinks I'm not getting full current. Thanks for any help.