Hello,
I am having issues getting my motors to run correctly with Mach3, but I get the feeling it's a stepper driver issue. I have an old Fireball V90 that I finally decided I would wire up. I grabbed a 3-axis kit from OMC stepper online that includes the M542T drivers that are apparently designed by Leadshine. Link here: https://www.omc-stepperonline.com/cn...2t-23hs45.html
I have 5TPI double-start leadscrews on X and Y. With microstepping set to 400 step/rev, I wager that I should have 2000 steps per unit in Mach3. To my surprise, however, X and Y are moving at TOTALLY different rates. This is in spite of the fact that both axes have the same settings.
Any thoughts on this issue? I am an electrical engineer with experience troubleshooting automation equipment, but this has been a humbling experience to say the least. I have attached a video and my dip switch settings for reference, along with that manual page.Tapatalk Cloud - Downlaoad File VID_20180315_194715.mp4
Sent from my Nexus 6P using Tapatalk