[Z-Hat]

I have a BMC-2416, I am having an issue with my ATC. The tool pocket won't come down through the control or on a tool change. When I actuate the manual override on the solenoid everything works as it's supposed too. I rewired the connections from the junction box and the tool changer control solenoid after finding some nicks in the wire insulation. Does anyone have any ideas on what to look at next? Or what the part number for the solenoids are so I can track down some diagnostic info on testing them.

[cnc-exit]

Write email i send you instruction manual

Išsiųsta naudojantis SM-G960F Tapatalk 4 Lt

[Z-Hat]

I sent you a message good sir thank you!

[cnc-exit]

[email protected]

Išsiųsta naudojantis SM-G960F Tapatalk 4 Lt

[Z-Hat]

Alrighty I shot you an email

[Z-Hat]

Thank you hopefully the answers are in there!

[Z-Hat]

Unfortunately I don't see a lot in there regarding the tool pocket down.

[cnc-exit]

Then maybe try check soilenoid. Tage tubes off. And manual switch down then up. Maybe pressure to low. Or it is dameged.



Išsiųsta naudojantis SM-G960F Tapatalk 4 Lt

[Z-Hat]

Manually switching them works, i.e hitting the bypass buttons on the solenoid. It looks (right now at least) like the solenoid isn't getting any power

[cnc-exit]

In there iswiring chexk 24 vdc.

Išsiųsta naudojantis SM-G960F Tapatalk 4 Lt