[LalloMan]

Hi guys - I need som help please

My Chinese 9060 3-axis CNC router was born with a parallel port and NC Studio software, but now I am working my way through the process of upgrading to Mach3 with an ethernet motion controller.
I'm pretty new in the CNC-world and now facing the problem of how to connect the VFD to the new motion controller without breaking something

The VFD is a Sunfar 2.2kw, model E300-2S0022

The motion controller is a XHC MK3-ET-T4S (V5.41)

I've attached images from the manuals:


Any help is appreciated

[Al_The_Man]

No experience with either but looks OK to me on the surface.
At least it doesn't look like you would do any damage to try.
Al.

[LalloMan]

Thanks for replying, Al


I have made a quick sketch showing the wiring, but I'm not sure if it correct
Can anyone confirm that the wiring is correct?


Thanks in advance.

[ger21]

As Al said, it looks right, but I've never used either of those devices either.

[safaenet]

Hi guys - I need som help please

My Chinese 9060 3-axis CNC router was born with a parallel port and NC Studio software, but now I am working my way through the process of upgrading to Mach3 with an ethernet motion controller.
I'm pretty new in the CNC-world and now facing the problem of how to connect the VFD to the new motion controller without breaking something

The VFD is a Sunfar 2.2kw, model E300-2S0022

The motion controller is a XHC MK3-ET-T4S (V5.41)

I've attached images from the manuals:


Any help is appreciated

Hi @lalloman. Were u able to get over with ur problem about xhc mk3? Im looking for a controller and some friends suggested me this model (ethernet version). Is it worth to buy it?

[mactec54]

Hi guys - I need som help please

My Chinese 9060 3-axis CNC router was born with a parallel port and NC Studio software, but now I am working my way through the process of upgrading to Mach3 with an ethernet motion controller.
I'm pretty new in the CNC-world and now facing the problem of how to connect the VFD to the new motion controller without breaking something

The VFD is a Sunfar 2.2kw, model E300-2S0022

The motion controller is a XHC MK3-ET-T4S (V5.41)

I've attached images from the manuals:


Any help is appreciated

Looks all correct Just check the control output FWD and 0V don't have any voltage and that it is just a switch/Relay switching