[kccrusher]

We have one of our Arrow1000s, 1998 A2100 control, that we're going to be installing a fourth axis rotary table in; does anyone have a sample program they would share so we can modify our post to accommodate this?? We are using Surfcam Traditional and the factory has no info on this control, well not much, so it's a custom mod to the post and they want sample programs to go by. The same for our Hawk200, but I haven't any programs for this, as we just got it going and all programs on the HD from the previous owner were lost when it failed.

[meckardt55]

Do you have the programming and operators manual?? It should be in there. Is it an integrated B axis?? Do you have the hardware, wiring and software option??

MIKE CNC Machine Services INC | Cincinnati Milacron MachinesCNC Machine Services

[kccrusher]

Do you have the programming and operators manual?? It should be in there. Is it an integrated B axis?? Do you have the hardware, wiring and software option??

MIKE CNC Machine Services INC | Cincinnati Milacron MachinesCNC Machine Services

Yes, you are correct and I do have both. I’ll just have to spend the time to dig through and get the info.

It does have the drive and correct motor on the units and will plug right in. It has the purchased option and just need to enable the axis when it’s installed.