Hello everyone.

I am using Catia for NC programming and I reached a big wall when trying to use the Back Boring operation. I have to use a Steiner Autofacer for a front and back sportface and I cannot figure out how to "start" the tool and start cutting.
I said start the tool as it needs to go slightly deeper than needed, do a counterclockwise motion at a certain RPM for the cutting area to come out and then start machining. Like in this
HTML Code:
https://www.youtube.com/watch?v=oNHesuWFjXw
.

Does anyone have experience with this and can give me a few hints?

Thank you.