Per your pic, the machine is not connected properly. The black wire to L1, the white wire to L3, the green wire to the right corner 5/8 nut the red jumper L1 to L2.
what is the white wire going to the 5/8 nut going to?
sportybob
Per your pic, the machine is not connected properly. The black wire to L1, the white wire to L3, the green wire to the right corner 5/8 nut the red jumper L1 to L2.
what is the white wire going to the 5/8 nut going to?
sportybob
The white wire was capped off in that picture. I removed it and ran the green wire to the stud. This was the before picture. I should have made that clear.
Now that I have everything I need to plug the machine in. I wanted to make sure I understand how to place the wires from the power cord to the receptacle.
Here's a picture of the outlet receptacle I am using and the wires from the power cord. Obviously the black is the ground (u-shaped).
But I am unsure on which goes to the larger flat prong and the smaller flat prong with the white and green wires.
Thanks once again to rl49. He walked me through power up after getting the machine under power. And even the beginning of some diagnosing some problems.
I guess this thread is done for now.
Here is a pic of the plug receptacle that rl49 sent to me for correct wiring. (220v single phase)