584,830 active members*
5,379 visitors online*
Register for free
Login
IndustryArena Forum > Machine Controllers Software and Solutions > Mach Software (ArtSoft software) > How to find the right pin and Port for my PWM / and or Analog voltage output?
Results 1 to 3 of 3
  1. #1
    Join Date
    Jan 2017
    Posts
    84

    How to find the right pin and Port for my PWM / and or Analog voltage output?

    Hi there
    I am trying to install my 3 phase Spindle using a Delta 7.5 KW Inverter.
    At the moment I can connect to output1 of my BOB(Smooth Stepper) Trough Mach3 by pressing the (Spindle CW F5) Bottom of Mach3, as the result The corresponding Light In front of it (Output1 in my BOB, I am attaching a Picture of it) will light Up. In the picture Output1 corresponds to O1. Also I can connect it to my Inverter, therefore I can Run/stop Spindle from mach3. (From the Pic. n4, I believe I am at Port 2 , Pin 1)

    But I just cannot light up the PWM corresponding Light in my BOB from Mach3 (What is the right port, and Pin for my PWM and/or Analog voltage?)
    What is it wrong in my mach3 setup? Presently I am dedicating Output1 to Run and/or Stop the spindle, but also, I think I am trying to use the same output1 to connect to my PWM , I really cannot figure it out, any advice is greatly appreciated.

    Regards
    Jhonansaro

  2. #2
    Join Date
    Jan 2017
    Posts
    84

    Re: How to find the right pin and Port for my PWM / and or Analog voltage output?

    Hi there

    following are also some pictures of my settings
    Attached Thumbnails Attached Thumbnails 8.jpg  

  3. #3
    Join Date
    Jan 2017
    Posts
    84

    Re: How to find the right pin and Port for my PWM / and or Analog voltage output?

    Hi there

    Case resolved,

    Thanks

Similar Threads

  1. Alternative Analog Output
    By engnerdan in forum Dynomotion/Kflop/Kanalog
    Replies: 1
    Last Post: 05-23-2017, 07:32 PM
  2. C23 Analog Output Not Working
    By Bob La Londe in forum Controller Cards
    Replies: 5
    Last Post: 06-19-2013, 06:55 PM
  3. CNC Brain analog output
    By cowpoke in forum CNC Machine Related Electronics
    Replies: 0
    Last Post: 03-23-2009, 02:50 AM
  4. change analog output voltage
    By Karl_T in forum CamSoft Products
    Replies: 4
    Last Post: 12-21-2005, 03:03 AM
  5. Output voltage on LPT port varies with OS on laptop?
    By Beezer in forum Computers / Desktops / Networking
    Replies: 7
    Last Post: 11-20-2004, 10:12 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •