Hi everyone.
I have a question, about tool radius o. Offset page, in 10m control.
When i go to the offset page, i can only entrer tool length, but no tool radius. In the Manual, an offset page is show with both length and radius, and the corosponding wear.
How can i 'activate' this?
IT should be said, that this machine is recovering from a total parameter clear. It was in storage for 2 years, and the battery died. I tried to get a parameter list, from MTB, but since the machine is from 1986,those parameters were lost. But I am able to run it now, after several weeks of trial and errors. Long story short, it may very well be a parameter/option, that need to be changed.
The machine is a Dah-lih mcv 1200.
THE pictures attached shows our current starte of the tool offset page, and the picture from the Manual, that I want to se on the machine.
I hope someone can point me in the right direction.
Thanks in advance.
Axl