VcarvePro 8.5
New to nesting.
I have watched a few videos but they did not address using multiple bits or when to set the cutting parameters..
Have a project where I am cutting the text with a 60 degree V bit then cutting the profile with a 1/4" bit.
There are ten items per 2x4' sheet and I need to five sheets for fifty pieces.
Do I have to do a tool change ten times per sheet, or could I engrave the ten pieces of text, then cut the profile of the ten pieces.
Another option would be to JIG mount the sheets, and engrave all the text on the five sheets then cut all the profiles of the five sheets.
Another Question regarding nesting:
Do I have one piece where I define the engraving and parimiter parameters on that piece then open nesting and define the ten nest quantity, and its ready to run?
Or, do I have one piece without any engraving and profile parameters, then open the nesting showing ten pieces then highlight all the engraving and set the parameters for that and do the same for the profile cutting of the ten pieces?
As you see I need some guidence here.
Thanks
Hager