[tommyb43]

Hi Folks I have just purchased an Mk3DRV

I need help with the wiring of this board to replace the Chinese clone in my 6090
any help would be appreciated
I did send an image of the controller when asking about the upgrade
and the upgrade instructions on Planet CNC are for the older control box

Regards Tom

[tommyb43]

OK got this installed and working Thanks to Planet CNC Tech Guys

Next Question Stepper Current I Have 4 57 two-phase 3A 150N.cm Steppers and work well
The Board Gets Very Hot and i am a little concerned if the on-board Stepper Drivers are being over worked
The Case has its own Drivers can these be used instead of the boards drivers ?

[PlanetCNC]

You could lower driver current value in settings: File/Settings/Motor Drivers -> Current

[tommyb43]

You could lower driver current value in settings: File/Settings/Motor Drivers -> Current

Now it won’t recognise the controller and driver is latest one installed


Sent from my iPhone using Tapatalk