Hey all.
When I powered up my Tsugami NT12 with Fanuc 3T control this morning things were not normal.
I have about 20 programs stored in the memory, and only 1 program was left as it should be. All other programs read:
.
M30
or some read:
5
M30
When I try to write my programs to the computer the list is:
.
M30
.
M30
5
M30
etc etc.
None of the programs are named, or have program numbers, like they normally do when I back them up.
Does anyone have a clue what could have happened?
I have checked voltage on batteries, it is good, and also the batteries are less than 6 months old, normally I change them once a year.
Can I just delete them and load my back up? If something is faulty it will just happen again.
Someone adviced me to initialize the program area of the memory, but I haven't been able to find a procedure for doing that anywhere.
Please help.