[horton_cody]

I've searched up and down and can't find the answers i'm looking for so i've resorted to asking.

I have a 1992 matsuura with an i80. When I try to use g54 with it, it alarms out and says unusable code. Is that not a purchased option or is that just a setting? I've been reading the manual and it shows to use g54 so i'm confused to how it won't work. Do I have to use an alternate code? I've read some about G92 but am not very clear on it.

Thanks all for any help!

[horton_cody]

I have figured out the control doesn't show a g54 offset page, the only offset page is just a workshift offset, and then the machine coordinates located on it.

Is there a setting or parameter to active this page so I can program with G54??

Help? Anyone? Lol