Good Morning guys and gals,

Im looking for some experience on this part in the picture on what the best cutter for this application would be,

Bit of back ground....

I Have an XYZ 1000LR 6 months old,

The hole metal workings is still very new to me even after 6 months of tool making.

This part is the deepest cavity tool i have ever done, So I am looking to be pointed in the right direction for a cutter to cut this depth. The shut off to the lowest point is just shy of 80mm.

My standard cutting depths per pass i run on the alloy this will be machined from are 5mm stepdowns.

I should also mention that I will need a roughing and finish tool.

Any Info is greatly received

Kindest Regards Tom