Hi Guys,
I'm running a mach3 plasma setup. I have the mach3 USB motion board. If my pierce and cut hight is higher than 1mm the tourch makes a small spark but does not fire. And then 95% of the time it disconnects all USB devices from my pc. The pc issue only happens when the tourch does not fire.
Thread: Mach3 plasma issue
Results 1 to 1 of 1
-
07-03-2018, 04:22 PM #1
Registered
- Join Date
- Mar 2018
- Posts
- 22
Mach3 plasma issue
Reply With QuoteSimilar Threads
-
Issue with Mach3 and USS
By kgresiak in forum Mach Software (ArtSoft software)Replies: 1Last Post: 07-03-2018, 12:08 AM -
More of a Mach3 issue...
By CROSSHATCH in forum NovakonReplies: 12Last Post: 06-18-2016, 01:28 AM -
Mach3 issue
By Andrew2111111 in forum Machines running Mach SoftwareReplies: 21Last Post: 02-10-2016, 10:41 AM -
Mach3 G28.1 issue...
By davek0974 in forum Mach Software (ArtSoft software)Replies: 8Last Post: 04-14-2014, 06:44 PM -
Differences Between Mach3 Mill and Mach3 Plasma?
By cjjonesarmory in forum Mach Plasma / LaserReplies: 0Last Post: 11-18-2010, 04:12 PM
Tags for this Thread
Posting Permissions
