[oggy]

Hi everyone,

I just have a simple favor to ask. I'm not sure if I'm in the correct place so shout at me if I'm not. I used to use bobcad to design in our shop but a number of years ago I switched to another cad system. However, I found a couple of files that I didn't convert to dxf and I don't currently have any way to view them. I was wondering if someone would be very sweet and convert them to dxf for me?
I can't attach the files to this post because apparently .bbcd files are not recognized by the system, but I could PM them if someone is interested. Also I'm not 100% sure which version of bobcad it was but I'm pretty sure it was v23 or older.,

Thanks very much!

Jesse

[The Engine Guy]

Jesse

You can upload the files here if you Zip them up, highlight all the files by holding down CTRL and selecting them, then right click and select the "Send to > Compressed (zipped) folder" and then just upload the Zip file. See imagebelow.

Regards
Rob

[oggy]

Thanks for the tip Rob...here's the files.

Jesse

[The Engine Guy]

Hi Jesse

See attached Zip file, all four files saved out as .dxf format, check if they are OK for you

Regards
Rob

[oggy]

That is perfect! Your awesome, thanks!

Jesse

[The Engine Guy]

You are welcome, enjoy

Regards
Rob