[luisjesus]

good afternoon people
I have 2 old cnc machines as you can see in the photos.
they have the motors running plus the controller are already old and I will to adapt a new controller
Do you have any idea what the best controllers I can adapt on this machine?

[ripperj]

Unless my phone is playing tricks you posted in a Place dedicated to Master Cam, you will probably get more eyes on the topic elsewhere.
You didn’t really provide a lot of info, how much money are you looking to spend? can do any of the work building the control? , or do you need a pre wired system(expensive)


Sent from my iPhone using Tapatalk Pro

[luisjesus]

good afternoon
I wanted to restore the machine, it's a three-phase machine where the engines are running.

I wanted to use the same motors and replace the controllers, but I do not know if it's possible

[KyleWarren]

Are the x y and z-axis powered by stepper motors if so it shouldn't be too difficult to control those with new stepper drivers. You said it is a three-phase machine I assume that means that the spindle is three phase you could control that with a VFD. You could use either an Arduino, Linux CNC, or Mach 3 to send signals to the stepper drivers it depends on what features you want and how much you are willing to spend.