Good afternoon,

I recently got a EL5-D0400 Leadshine driver, I'd like to use it on a M01330A servo motor.
After testing my wiring job I got to configure the drive. I don't have a lot of experience when it comes to configuring servo drivers, after downloading the Leadshine protuner L5-ACH series, I connected my computer to the driver without any errors.
But then there are the parameters, the manual isn't clear on which parameters to adjust and which value each a parameter should be depending on your servo properties.

I am really overwhelmed with all the parameters and haven't figured out on how to adjust them properly after a few hours of trial and error. I spent some time researching the parameters on the internet, it unfortunately left me none the wiser.
Is there someone who can put me on the right track or would like to help me out?

Thanks in advance,
Robin