[Rafal-P]

Hello,

I have a problem with Fagor 800 TG-I like this


The monitor displays Error 064.

I checked the physical inputs and then displayed the IO status:
I1 - Emergency Stop =1
I2 - End Cover SW =1
I3 - Head Chuck Guard SW =1
I4 - Saddle Guard SW =1


Every of Output are OFF.


Below the scheme IO1 and IO2



Someone had a similar problem?

Best refards
Rafal

[kcho]

Maybe plc is in stop state

Carlos Cabrera

[eyupyupi]

Hello Rafal

I just bought a lathe and all axis moved perfectly than after a new power up I got the same message and machine will not move.
Did you sort you problem out and if yes how??
One another point the attachments are not visible anymore??

thanks

regards
Eyup

Hello,

I have a problem with Fagor 800 TG-I like this


The monitor displays Error 064.

I checked the physical inputs and then displayed the IO status:
I1 - Emergency Stop =1
I2 - End Cover SW =1
I3 - Head Chuck Guard SW =1
I4 - Saddle Guard SW =1


Every of Output are OFF.


Below the scheme IO1 and IO2



Someone had a similar problem?

Best refards
Rafal

[kcho]

Please tell the machine brand and model. Check I1

[Rafal-P]

Hello,

Unfortunately, the problem is still not resolved.
It looks like the problem is not hardware. I hope I'm wrong ;-)

best regards
Rafal

[Rafal-P]

Hello,

Unfortunately, the problem is still not resolved.
It looks like the problem is not hardware. I hope I'm wrong.

best regards
Rafal

[kcho]

Oh. I was a Fagor Tech. Where is the machine?

[Rafal-P]

Oh. I was a Fagor Tech. Where is the machine?

Iceland

[Rafal-P]

Iceland

The CNC 800 TG-I has an I / O1 - 37 Pin and I / O2 - 37 and I / O3 input card installed.


The documentation shows that the EMERGENCY input is I1.
In my case, I1 = 1.
This is how it looks in the input status preview.

So it looks like the controller sees I1 that it's ok.

Best regards
Rafal

[Rafal-P]

Maybe plc is in stop state

Carlos Cabrera

Hi Carlos

Do you know how to check it?

Best regards
Rafal

[Rafal-P]

Hello,

Does anyone know how to check the status of inputs I42 - I104 and outputs O25 - 064?
These are the I / O between PLC and CNC.


Best regards
Rafal

[Rafal-P]

Hello,

I have a problem with Fagor 800 TG-I like this


The monitor displays Error 064.

I checked the physical inputs and then displayed the IO status:
I1 - Emergency Stop =1
I2 - End Cover SW =1
I3 - Head Chuck Guard SW =1
I4 - Saddle Guard SW =1


Every of Output are OFF.


Below the scheme IO1 and IO2



Someone had a similar problem?

Best refards
Rafal

Problem SOLVED ;-)

The PLCI was in STOP mode.

[proben]

How to put PLCI into RUN mode?

[Patxiu]

Hello Rafal,

How did you put it in RUN?

Regards, Patxi.

[bdaniele79]

Hello
I have the same problem.
How to put PLC into RUN mode?
Regards
Daniele