502,649 active members
6,853 visitors online
Register for free
Login
Results 1 to 1 of 1
  1. #1
    Junior Member
    Join Date
    Jul 2018
    Posts
    2

    ps error 128 trying to DNC

    I have a milling center with a Fanuc O-MD control and I'm having problems to DNC run a program from the computer.

    I select MEM-DNC and press the Cycle Start key and I get LSK flashing in the lower right corner of the screen.
    When I start transmitting from the computer, the first two lines go through and then I get a ps 128 alarm. First line is of code is the % character.

    From the OFFSETS screen pressing the OUTPUT-START key I get all the data sent correctly to the computer, so I assume cable and RS2332 parameters are correct.
    Is this assumption correct?


    Any ideas?
    Please

  2. #2
    Member
    Join Date
    May 2016
    Posts
    342

    Re: ps error 128 trying to DNC

    What happens when you load a program to the memory without dnc

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •