[david_geng]

Hi, there,

I just received my Syil SX3 cnc mill yesterday. I'm setting it up in my garage. I think there is need to connect a few wires between the CNC control box and the original mill control box. So far I've connected 2-wire emergency stop connector, a 10pin or so connector, and there is still another connector looking like a power supply no where to go. Can anyone help? thanks

David

[dafowfidy]

Remove the upper pannel, there is a plug up there that it connects to.

[metalworkz]

Hello David,
You will find some information on the SyilAmerica website under the support tab. Here is a link:
http://www.syilamerica.com/support.asp
Regards,
Wes

[Green0]

Yeah why they ship the damn things with hanging dissconnected BS I have no idea.

Sounds like a good way to create issues.

I might still have something not connected. I thought everything was done, and the steppers had no power, so I called and they told me about the control box power supply.

That should be numbered, and under the acess pannel up top there are numbered wires. If you connect those wires to their corresponding numbers on the socket thing (three lead connection), your steppers will get power.

That means they will get warm when you turn the machine on, and not neccessarilly anything else. Mine do just that and nothing more.

[syil]

i have been email the manual to Syil UK.
please contact them for those flies.
becuase the carton if we put the control box connected was too small and hardly to closed.that is reason.

Syil China
Xushuo

[Green0]

I understand it ships smaller, but I also think it would eliminate a lot of tech support issues because people could know going in that everything was properly wired, and rule out that possibility.

That might be worth different crate dimensions.