I have been a member here for some time. I have always found great information on this board. I am now stuck on how to light up a spindle. I have a 2'x2' cnc router with a box stock 400W Chinese spindle (see attached) and a DC12-60 Spindle Controller that I want to get running. I have rebuilt the controller with a G540 and UC100 running under Mach3. All of my Axis are running. I realize that the spindle is not 3PH brushless and can not use VFD.
Can I run this two wire spindle with the G540 and this controller card. The card has PWM and GND connections labled "Mach3" If yes How do I do it?
Any help would be appreciated as I have been searching for an answer for days.
Thks,
Kim