Dear Experts
Is there any specific tool to pull a vacuum pump stuck rotary vane (fan)
https://imgur.com/a/Pnu7PAS
Yes, I did remove the circlip that is attached to the shaft
Thanks
Dear Experts
Is there any specific tool to pull a vacuum pump stuck rotary vane (fan)
https://imgur.com/a/Pnu7PAS
Yes, I did remove the circlip that is attached to the shaft
Thanks
I normally use a couple of screwdrivers or small pry bars. Try to get the tips as close to the shaft as possible. But sometimes the fan breaks anyway.
Jim Dawson
Sandy, Oregon, USA
Bearing/Pulley remover?
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
First of all you have to take the circlip off
Make no mistake between my personality and my attitude.
My personality is who I am. My attitude depends on who you are.
Thanks guys for your help and insights